Welcome to the homepage of
Sie haben Schweißprobleme? Qualitätsprobleme? Wir haben Antworten und Lösungen!! Das schweißt zusammen.... seit 2011
We monitor, qualify and optimize the production of your components and you demand quality in steel construction, mechanical engineering, pressure vessels, railway in the field of welding, destructive and nondestructive testing of materials and in the field of corrosion protection. We monitor production processes, optimizing welding and manufacturing processes based on failure analysis and fault pattern analysis, in short, we take over your quality assurance of your suppliers.
We create cost / usage calculations of the used welding processes. We monitor the qualification of welding procedures from your Suppliers under the standards of DIN EN ISO 156XX.
A safe and proper application we offer in the following standards and standard series:
EN 1090, GL Wind 2012 AD 2000 Merkblatt HP 5/1 and HP 5/3, DIN EN ISO 156XX, DIN EN ISO 3834, ISO 9001, DIN EN 10204, DIN EN ISO 9606, DIN EN ISO 12944, ISO 9712 for VT + PT + MT and RT and further referenced standard and regulations in the area of welding technology, testing equipment and coating technology (corrosion protection).
Here are a few examples
After finishing inspection by our inspectors on behalf of the client company the jacket foundations have been lifted for further assembly of technical equipment. The steel inspections were executed according the rules of GL Wind 2012 and its referenced standards such as EN 1090, DIN EN ISO 5817, and standards in the range of destructive and non-destructive material testing
Offshore coatings must be monitored in detail in the area of production to the requirements agreed to review and confirm during acceptance fulfilled. Defining a Coating Manual and describe which we check in your order your own requirements. Here you access to experience and knowledge of our employees in the combined action of several offshore wind farms and experience from projects in the offshore oil and gas exploration off the coasts of Newfoundland, Texas and the west coast of Africa it with the appropriate international regulations such as ASME, ASTM etc.
During the ultrasound examination NDT operator detected rolling defects (doubling) in the heat-affected zone, the customer has ordered material supply with 3.2. Material certificates according to EN 10204 rather than the rule. Here was an independent audit of our inspectors, commissioned by the builders, the key to success, which was withdrawn from the productionprocess again this defective component. Regular internal training as part of a so-called "lessons learned" discussion, trains our inspectors, which then ensures the product safety of your purchased parts. It was a rolled and welded Tower CAN an offshore jacket foundation. Additional testing was performed as well as the initial test, conducted in accordance with the valid for Offshore Structures rules GL Wind in 2012 and the therein referenced standards.